SemperSonic™ UFTL Compact Transit Time Flow Meter

Unique Features of Series UFTL

• Series UFTL provides easy and low cost installation by clamping on the outside of existing piping systems.
• Non-invasive system allows solids to pass through the pipe with no affect on meter. Y-strainers or filtering devices are not needed.
• Greater accuracy can be attained in applications consisting of entrained gases. The Series UFTL will automatically correct displayed flow rates and electronic outputs.
• Direct interface is provided to data collection systems via 4-20mA output and either TTL - pulse or simulated turbine meter outputs that are proportional to fluid flow rate.
• UltraLink™ software utility allows configuration, calibration and troubleshooting of each meter.
• Series UFTL is a bi-directional flow measurement system. Multiple totalizers simultaneously operate to measure forward total, reverse total and net total.
• Designed to replace mechanical flow meters in applications where liquid conditions tend to damage or impede mechanical flow meter operation. No maintenance is required.
• Series UFTL can be used on applications such as well water and other liquids with moderate amounts of suspended solids or aeration.

Typical Flow Applications

• Ultrapure liquids
• Deionized Water
• Water filter-bed effluent
• Hydraulic oil
• Refined hydrocarbon
• Well water
• Reclaimed water
• Ground water
• Cooling tower water
• Gray water

SemperSonic UFTL flow meters clamp onto the outside of existing pipe and do not contact the internal liquid. This advanced product provides instantaneous rate and accumulated flows along with 4-20mA and pulse outputs. Inherent advantages over competitive technologies include ease of installation, fluid compatibility, immunity to suspended solids and gas pockets and a large, bi-directional measuring range. UFTL is housed in an enclosure suitable for outdoor mounting and is available with and without a local display. Integral mount transducers are available for pipes 2 inches [50 mm] and smaller. Pipe sizes from 1/2- inch [12 mm] through 100-inches [2540 mm] can be accommodated with remote mount transducers. A software utility is available for customer configuration and in-field calibration

The SemperSonic flow measurement system is a cost-effective, versatile investment that can be readily configured for piping from 2" (50mm) and higher using the large transducers. The small pipe transducers are capable of measurement on piping from 1/2" (12mm) to 2" (50mm). This unit clamps on to the surface of the pipe providing easy installation with no down-time. No maintenance is required since the transducers never come in contact with the fluid media.

Additional features include:

• Non-invasive clamp-on transducers that are simple and cost efficient to install. Since the transducers do not contact the liquid, fouling and maintenance are eliminated.
• Small Pipe Transducer set for pipe or tubing 1/2" - 2".
• Large Pipe Transducer set for pipes 2" and above.
• Cable lengths in standard runs of 20', 50', 100'.
• NEMA 6 weather proof and submersible classification with optional Class 1 Div. 1 I.S. for hazardous locations.